Skicář Lomená čára

From FreeCAD Documentation
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
This page is a translated version of the page Sketcher CreatePolyline and the translation is 27% complete.
Outdated translations are marked like this.

Skicář Lomená čára

Umístění Menu
Náčrt → Skicář Konstrukce → Vytvořit Lomenou čáru
Pracovní stoly
Skicář
Výchozí zástupce
Nikdo
Představen ve verzi
-
Viz také
Skicář Přímka

Popis

Tento nástroj funguje podobně jako Skicář Přímka, ale vytváří postupně přímkové segmenty, které jsou spojeny v jejich vrcholech. Při spuštění nástroje se ukazatel myši změní na bílý křížek s červenou ikonou lomené čáry. Souřadnice ukazatele jsou vedle zobrazovány v reálném čase.

Polyline started with a line, a tangent arc, a perpendicular arc then a tangent line.

Použití

Nástroj má vícenásobný mód, který může bý přepnut klávesou M. Například můžete kreslit tečné nebo kolmé oblouky následované přímkovým nebo obloukovým segmentem. Jenom opakovaně stiskáváte M pro přepínání mezi různými módy.

  1. Press the M key: the new segment is a line which is perpendicular to the previous segment.
  2. Press the M key again: the new segment is a line which is tangential to the previous segment.
  3. Press the M key again: the new segment is an arc which is tangential to the previous segment.
  4. Press the M key again: the new segment is an arc which is perpendicular (left) to the previous segment.
  5. Press the M key again: the new segment is an arc which is perpendicular(right) to the previous segment.
  6. Press the M key again: You are again in the state where you started; the line is only connected with a coincidence to the previous segment.
  • version 0.18 and above While in any of the arc modes, holding down the Ctrl key (MacOS: CMD key) and moving the cursor causes the arc to snap by increments of 45 degrees, relative to the previously created polyline segment.
  • Pick points on an empty area of the 3D view, or on an existing object (auto constraints must be active in TaskView).
  • Pressing Esc or clicking the right mouse button before closing the polyline to a loop ends the current polyline and you can continue with a new one. Pressing Esc or clicking the right mouse button again ends the polyline function.
  • Pressing Esc or clicking the right mouse button after closing the polyline to a loop ends the polyline function.