Sketcher CreatePolyline/cs: Difference between revisions

From FreeCAD Documentation
No edit summary
(Created page with "==Použití==")
Line 13: Line 13:
''Polyline started with a line, a tangent arc, a perpendicular arc then a tangent line''
''Polyline started with a line, a tangent arc, a perpendicular arc then a tangent line''


==How to use==
==Použití==





Revision as of 22:28, 3 November 2018

Skicář Lomená čára

Umístění Menu
Náčrt → Skicář Konstrukce → Vytvořit Lomenou čáru
Pracovní stoly
Skicář
Výchozí zástupce
Nikdo
Představen ve verzi
-
Viz také
Skicář Přímka

Popis

Tento nástroj funguje podobně jako Skicář Přímka, ale vytváří postupně přímkové segmenty, které jsou spojeny v jejich vrcholech. Při spuštění nástroje se ukazatel myši změní na bílý křížek s červenou ikonou lomené čáry. Souřadnice ukazatele jsou vedle zobrazovány v reálném čase.

Polyline started with a line, a tangent arc, a perpendicular arc then a tangent line

Použití

The polyline always starts with a straight line segment: click - move the mouse - click. Move the mouse again. After placing the first line segment, the Sketcher polyline tool has multiple modes that can be toggled with the M key. For example you can draw tangent or perpendicular arcs following a line or arc segment. Repeatedly pressing the M key toggles through these different modes:

  1. Press the M key: the new segment is a line which is perpendicular to the previous segment.
  2. Press the M key again: the new segment is a line which is tangential to the previous segment.
  3. Press the M key again: the new segment is an arc which is tangential to the previous segment.
  4. Press the M key again: the new segment is an arc which is perpendicular (left) to the previous segment.
  5. Press the M key again: the new segment is an arc which is perpendicular(right) to the previous segment.
  6. Press the M key again: You are again in the state where you started; the line is only connected with a coincidence to the previous segment.
  • v0.18 and above While in any of the arc modes, holding down the Ctrl key (MacOS: CMD key) and moving the cursor causes the arc to snap by increments of 45 degrees, relative to the previously created polyline segment.
  • Pick points on an empty area of the 3D view, or on an existing object (auto constraints must be active in TaskView).
  • Pressing Esc or clicking the right mouse button before closing the polyline to a loop ends the current polyline and you can continue with a new one. Pressing Esc or clicking the right mouse button again ends the polyline function.
  • Pressing Esc or clicking the right mouse button after closing the polyline to a loop ends the polyline function.