Верстак Image

From FreeCAD Documentation
Revision as of 11:44, 6 September 2016 by Baritone (talk | contribs)

Модуль изображений управляет различными типами графика растровых изображений, и позволяет открывать их в FreeCAD. В настоящее время модуль позволяет открывать файлы формата .bmp, .jpg, .png и .xpm в отдельном окне просмотра.

Верстак Image так же позволяет импортировать изображение на плоскость в трёхмерном пространстве FreeCAD. Эта функция так же доступна через вторую кнопку на верстаке изображений. .
Импортируемое изображение может быть прикреплено как эскиз к одной из трёх плоскостей (XY/XZ/YZ) с положительным или отрицательным смещением.
Эта функция доступна лишь если у Вас открыть документFreeCAD.

The image can be moved in 3D-space by editing the placement in the Property editor.
The major use is tracing over the image, in order to generate a new part at using the image as template.

The image is imported with 1 pixel = 1mm. Therefore it is recommended to have the imported image in a reasonable resolution. The image can be scaled by editing the "XSize" and "YSize" values in the Property editor. The image can be also moved by editing the X/Y/Z-values in the Placement-Tab. The image can also be rotated around any axis by using the placement-dialogue.

Tip:
Tracing with sketcher elements over an image works best if the image has a small (negative) offset to the sketch plane.
You can set an offset of -0,1 mm at import or later by editing the placement of the image.

Tools

Image Import

Raytracing Module/ru
Draft Module/ru