FEM ConstraintContact/it: Difference between revisions
Renatorivo (talk | contribs) (Created page with "Crea un vincolo FEM di contatto tra 2 superfici.") |
Renatorivo (talk | contribs) (Replaced content with "==Uso==") |
||
Line 5: | Line 5: | ||
Crea un vincolo FEM di contatto tra 2 superfici. |
Crea un vincolo FEM di contatto tra 2 superfici. |
||
<div class="mw-translate-fuzzy"> |
|||
==Uso== |
==Uso== |
||
#Cliccare su [[Image:FEM_ConstraintContact.png|32px]] o usare {{KEY| FEM}} → {{KEY|[[Image:FEM_ConstraintContact.png|32px]] Vincolo contatto}} dal menu principale. |
|||
#Selezionare la faccia principale (master). |
|||
#Selezionare la faccia secondaria (slave). |
|||
#Inserire la rigidezza del contatto. |
|||
#Inserire il coefficiente di attrito. |
|||
</div> |
|||
#Click on [[Image:FEM ConstraintContact.png|32px]] or choose {{KEY|Model}} → '''Mechanical Constraints''' → {{KEY|[[Image:FEM ConstraintContact.png|32px]] Constraint contact}} from the top menu. |
#Click on [[Image:FEM ConstraintContact.png|32px]] or choose {{KEY|Model}} → '''Mechanical Constraints''' → {{KEY|[[Image:FEM ConstraintContact.png|32px]] Constraint contact}} from the top menu. |
Revision as of 14:05, 4 March 2018
Vincolo contatto |
Posizione nel menu |
---|
Modello → Vincoli meccanici → Vincolo contatto |
Ambiente |
FEM |
Avvio veloce |
Nessuno |
Introdotto nella versione |
- |
Vedere anche |
Tutorial di FEM |
Descrizione
Crea un vincolo FEM di contatto tra 2 superfici.
Uso
- Click on or choose Model → Mechanical Constraints → Constraint contact from the top menu.
- Select the master face.
- Select the slave face.
- Enter a contact stiffness.
- Enter a friction coefficient.
Limitazioni
- Il vincolo contatto può essere applicato solo a due facce.
- The contact constraint can only be applied to two faces.
Note
- La rigidezza del contatto dovrebbe essere 10 volte il modulo di Young del materiale per avere un contatto forte. Più alto è il valore di rigidezza di contatto, più è forte il contatto tra le superfici.
- La faccia secondaria è la faccia che penetra nella faccia principale, e subisce quindi una deformazione maggiore.
- Il vincolo contatto utilizza la *CONTACT PAIR card in CalculiX. Il vincolo usa il metodo Face-to-Face penalty e la formulazione del contatto è spiegata in dettaglio in http://web.mit.edu/calculix_v2.7/CalculiX/ccx_2.7/doc/ccx/node112.html
- The contact stiffness should be 10 times the young's modulus of the material for hard contact. The higher the value for contact stiffness, the harder the contact between surfaces.
- The slave face is the face which penetrates into the master face, and therefore experiences more deformation.
- The *CONTACT PAIR card is used for modeling contact in CalculiX. The constraint uses Face-to-Face penalty contact and the contact formulation is explained in detail at http://web.mit.edu/calculix_v2.7/CalculiX/ccx_2.7/doc/ccx/node112.html