Draft Snap: Difference between revisions

From FreeCAD Documentation
mNo edit summary
Line 23: Line 23:


[[Category:User Documentation]]
[[Category:User Documentation]]

{{languages | {{se|Draft Snap/se}} }}

Revision as of 04:50, 12 September 2010

Snapping means "gluing" your next 3d point onto an existing point.

Snapping in the Draft module has two modes: an active mode and a passive mode.

Passive mode

You are automatically set in passive mode while drawing. In passive mode, if your mouse cursor hovers over an existing object, your point will be snapped to the nearest point on the object. An open circle symbol appears.

Active mode

To switch to active mode, press CTRL while drawing. In active mode, either a closed circle or an open or closed square, depending on the snap type, will appear. In all tools that support snapping, following snap locations are available:

  • Endpoint of lines/polylines
  • Midpoint of lines/polylines
  • Center of circles and arcs
  • Quadrant points of circles and arcs
  • Endpoints of arcs
  • Vertically or horizontally aligned points on lines/polylines, if constraining (SHIFT)
  • Intersection between segments

In tools that support both snapping and constraining, the combination of both behaviours (SHIFT+CTRL) can extend much the snapping possibilities.

Available translations of this page: Template:Se