Draft Constrain: Difference between revisions

From FreeCAD Documentation
No edit summary
mNo edit summary
Line 8: Line 8:


[[Category:User Documentation]]
[[Category:User Documentation]]

{{languages | {{se|Draft Constrain/se}} }}

Revision as of 05:55, 9 September 2010

To use constraining, press SHIFT while drawing.

In all tools that support constraining, you can force the next point to be constrained horizontally or vertically in relation to the last point entered. The vertical or horizontal constraining depends on where your mouse lies when you press SHIFT. If you are more north or south from the last point, it will be vertical. If you are more east or west, it will be horizontal. To change, just release SHIFT and press again at another location.

Some tools, like offset and trimex use constraining differently. They do not constrain vertically or horizontally but use a different way more adapted to the particular tool, like for example constraining the operation to a certain polyline segment.

Available translations of this page: Template:Se