# Part Torus

This page is a translated version of the page Part Torus and the translation is 5% complete.

Outdated translations are marked like this.
Other languages:
čeština • ‎Deutsch • ‎English • ‎español • ‎français • ‎italiano • ‎polski • ‎română • ‎русский • ‎svenska • ‎中文（中国大陆）‎
Previous: Sphere

Part Torus

Menyplacering
Part -> Torus
Arbetsbänk(ar)
Part_Module,Complete
Standard genväg
None
-
Se även
Part_CreatePrimitives

## Description

Creates a simple parametric torus, with position, angle1, angle2, angle3, radius1 and radius2 as parameters.

## Usage

1. Switch to the Part workbench.
2. Invoke the Part Torus command several ways:
• Press the button.
• Use the Part → Torus entry in the top menu.

Result: The torus will be positioned at origin (point 0,0,0) on creation.
The angle parameters (angle1, angle2, angle3), as well as the radius parameter (radius1 , radius2) parameters permit to parametrize the torus, see next section.

## Option

Parameter

A torus can be assimilated to a small disc that makes a circular orbit around an imaginary axe. Thus the parametric torus is defined by the following parameters:

• Radius2: Radius of the disc defining the form of the torus
• Angle1: 1st angle to cut / define the disc of the torus
• Angle2: 2nd angle to cut / define the disc of the torus
• Angle3: 3rd angle to define the circumference of the torus.

as well as the standard set of placement parameters. The pictures below give a visual overview of the parameters antecedently mentioned:

The parameter Radius1 has a value of 20 mm.

The parameter Radius2 has a value of 2 mm.

The parameter Angle1 has a value of -90°. Notice that, the "angle measure" tool cannot display negative angle. Considered the displayed value in picture as "-90°".

The parameter Angle2 has a value of 90°.

The parameter Angle3 has a value of 90°.

Previous: Sphere