View Issue Details

IDProjectCategoryView StatusLast Update
0004128TechDrawFeaturepublic2022-01-15 15:39
Reporterwandererfan Assigned Towandererfan  
PrioritynormalSeverityminorReproducibilityhave not tried
Status feedbackResolutionopen 
Platformall 
Target Version0.20 
Summary0004128: Allow Angled Section Views
DescriptionForum discussion

Currently, the Section tool will only create sections in 4 directions (left, right, up, down). There are occasions where a Section at an angle (say 45*, left/down to right/up) to the Base view would be useful.
Additional InformationThere was a question about this in the German forum some time ago. German forum thread re angled Section
TagsNo tags attached.
FreeCAD Information

Activities

wandererfan

2022-01-15 15:37

manager   ~0016215

This can be accomplished by changing the Direction and SectionNormal properties of the SectionView after it is created.

wandererfan

2022-01-15 15:39

manager   ~0016216

Is this request still valid given the ability to adjust the direction after creation?

yorik

2022-03-03 13:55

administrator   ~0016822

This ticket has been migrated to GitHub as issue 5988.

Issue History

Date Modified Username Field Change
2019-09-13 11:49 wandererfan New Issue
2019-09-13 12:09 wandererfan Additional Information Updated
2021-02-06 06:38 abdullah Target Version => 0.20
2022-01-15 15:37 wandererfan Note Added: 0016215
2022-01-15 15:39 wandererfan Assigned To => wandererfan
2022-01-15 15:39 wandererfan Status new => feedback
2022-01-15 15:39 wandererfan Note Added: 0016216